Motorcycles Information

How to Remove Your Mk2 Mini Moto Engine


Many mini moto modifications will require you to remove the engine from the mini moto. This is why I have produced the following guide.

Firstly you will need to remove the mini moto's fairing.

Start with the seat fairing, unscrew the four seat screws and remove the seat. Unscrew the screw at the front end of the seat fairing and remove the petrol cap. The fairing can now be lifted from the mini moto. Replace the fuel tank petrol cap and remove the fuel tank by pulling the rubber tube of the nipple on the top of the carburettor. You may want to double the rubber fuel tube over and secure it in this position with a clothes peg. This is to stop fuel leaking out.

Remove the bottom fairing by unscrewing the holding bolts (two on each side), this frees the bottom fairing from the top. Unscrew the two bolts on the underside of the bottom fairing. The bottom fairing is now free. The top fairing is only now held on by one last bolt located in between the handle bars at the front of the mini moto.

Once you have removed the fairing, you will need to take the chain off the front sprocket. To do this loosen the back wheel nuts and the tensioning bolts. The back wheel can now be manoeuvred toward the front sprocket loosing the chain. When the chain is loose enough you can remove it from the front sprocket.

Remove the pull start from the engine by unscrewing the three holding screws. Once the pull start has been removed you will see the wire that comes from the stop switch. Unplug this.

The throttle cable can be removed from its fitting on the top of the carburettor. Pull the rubber seal up so that the locking nut can be unscrewed, the throttle can now be pulled from the carburettor along with the needle valve and spring.

The next step is to Remove the Exhaust. The exhaust is fixed to the mini motos frame by a bolt located just under the seat fairing toward the back of your mini moto. Undo this bolt with a spanner and an alan key. The exhaust is fixed to the underside of the engine by two bolts via a gasket. Remove the two bolts with an alan key making sure that you do not lose the gasket washer. The exhaust can now be slid out past the engine and removed form the mini moto.

The engine is free from its mechanical fittings, the engine then needs to be removed from the mini motos frame. The bolt at the top of the engine must be undone first using the alan key. The three screws located on the underside of the engine are the last fixings to be undone. The engine can now be completely removed from the mini moto.

Matt Tong has been importing and riding Mini Motos for two years. For expert advice and Mini Moto information please visit http://www.minimotosandmore.com


MORE RESOURCES:


Deadspin
Steelers + Motorcycles = Bad News
Deadspin, NY - 5 hours ago
Jealous of all the attention devoted to Ben Roethlisberger and his motorcycle, Steelers offensive lineman Barrett Brooks took to the streets last night. ...


Loud motorcycles disturb neighborhood’s peace THE WATCHDOG
Kansas City Star, MO - 19 hours ago
Motorcycles are buzzing through Jim Roe’s neighborhood in Gladstone, with riders gunning their engines so loud that it rattles his windows. ...


Indian Motorcycles to open headquarters in NC
Gilroy Dispatch (subscription), CA - 22 hours ago
... Mass. to become the new home of Indian. The brand is known for building motorcycles that competed with Harley-Davidson's. Production ...



New York Times
Their Motorcycles Are in the Mail
New York Times, United States - Aug 4, 2006
By MATTHEW HEALEY. EVEN as a youngster, Penny Nickerson loved motorcycles. Growing up in a family that considered motorbikes unladylike ...
MOTORCYCLE STAMP EVENT ROLLS INTO HARLEYVILLE The State
all 2 related


Teen killed as minibus and car collide
The Age, Australia - 12 hours ago
... Police want to interview the riders of two Harley-Davidson motorcycles seen heading east on the wrong side of the road, overtaking a line of cars, just before ...
Teen killed in minivan crash Daily Telegraph
all 11 related


Motorcycle thefts up in Rock Hill
Rock Hill Herald, SC - 21 hours ago
... Nationally, motorcycle theft actually decreased slightly from 2004, but the 1,961 motorcycles stolen in South Carolina was just one short of the previous ...


Man Dies in Bullet Bike Wreck
KSL-TV, UT - 22 hours ago
... Inflammatory and tabloid-esque reporters love to call sport motorcycles "bullet bikes", which is a complete misnomer intended solely for the purpose of ...


Rwanda to receive motorcycles for Gacaca
African News Dimension (subscription), South Africa - Aug 5, 2006
The Rwandan minister of Information in the Prime Minister's office Prof Laurent Nkusi has confirmed that Rwanda will receive 106 motorcycles to be given to the ...


Learn to thank those deafening motorcycles
Pocono Record, PA - Aug 4, 2006
Thanks to that letter from a member of the National Harley Owners Group we now know that "loud pipes" are a safety device for bikers and that it probably is ...


Classic motorcycles featured on stamps
Barre Montpelier Times Argus, VT - Aug 4, 2006
... "I really didn't know what I had, I just knew that I loved it. I have always loved motorcycles and been a rider," she said. She ...

home | site map
© 2006 Indexadvertisements.com

Useful Links

   
Biometrics Solutions Ayurvedic Biometrics Products Job opportunities
Tech News Online Advertisement Software Development Investments Guru
Biometrics Integrated Chipsilicon Matrimonial Semiconductors